Page 1 of 1
Dovetails?
Posted: Mon Nov 22, 2010 2:31 pm
by donarthur
Hello! I'm a new member and cannot find any reference to making dovetails with the Shark. Can the Shark be programmed to cut dovetail joints - pins and tails?
Thanks very much in advance! Don
Re: Dovetails?
Posted: Mon Nov 22, 2010 4:22 pm
by GARYR6
You should search Vectric.com/forum, the software provider that came with your shark. I believe you will find joints that can be cut there and the discussion that follows.
Good luck AND WELCOME TO THE FORUM.
Re: Dovetails?
Posted: Mon Nov 22, 2010 7:00 pm
by Bob
Go to this website and check out the wood joints designed for cnc machining.
http://flexiblestream.org/Digital-Wood-Joints-001.php
Bob
Re: Dovetails?
Posted: Mon Nov 22, 2010 9:47 pm
by donarthur
Thanks very much for your advice and warm welcome! I look forward to learning more. Best regards, Don