just purchased shark pro plus. it works with simple control panel but would like to use mach3. pretty sure
that i have installed software correctly but no response by router in mach3. is there a step by step proceedure
for getting mach3 up?
ncpod not working with mach3
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: ncpod not working with mach3
The new controller firmware is not compatable with Mach 3.
We made a special firmware for you to use.
Please check out the downloads section of our site.
We made a special firmware for you to use.
Please check out the downloads section of our site.
-
- Posts: 2
- Joined: Tue Dec 07, 2010 9:16 pm
Re: ncpod not working with mach3
thank you Tim,
I will check it out. Been using the initial tools and in the middle of cutting abrasive plastic with
a new motor, etc. thanks again, peter
I will check it out. Been using the initial tools and in the middle of cutting abrasive plastic with
a new motor, etc. thanks again, peter