Shark HD4 laser

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk

Post Reply
Posts: 5
Joined: Thu Dec 15, 2016 11:12 pm

Shark HD4 laser

Post by Dustnuri »

After 4 months I decided to hook up the laser up to my Shark!! FYI it was super easy. I was up and running within 10 minutes. Did a test run that took about 16 minutes. On a side note!!!! Make sure to set your z clearance back when switching back to wood. The laser is recommended to be set at .001. Unlike the .2 for wood.

Post Reply