I am into week for of running my new HD4 fairly successfully. Today I took to much off of a pass and the machine lost all power. I see no external reset button and after removing the case I see nothing visible there either. Looking for a little help / direction on this. I don't have access to an electrician till Monday and had big plans for this weekend yet.
I found the fuse.
Thanks in advance
HD4 lost power.......reset button?? Disregard, found the fu
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: HD4 lost power.......reset button?? Disregard, found th
There should be a extra fuse inside the fuse holder! Did you try replacing it and start up the machine again?
It's not a expensive fuse. I believe you can get them at almost any hardware store.
It's not a expensive fuse. I believe you can get them at almost any hardware store.
Re: HD4 lost power.......reset button?? Disregard, found th
You should only go deep as half your bit size. example If you use a 1/4 end mill, the depth of cut should be 1/8
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.