CNC Shark Forum

I Figure on making some stools with butt impression seats (carved chair seats) but I do not have any ideas on dimensions (what is considered standard (is there such a thing?)).

Probably use VCarve, 3D carving and a round bull nose bit to do most of the work. Only guessing here.

Can't find any Youtube about Vetric and chair bottoms. I may check out how to do spoons and go from there.

Ideas and help please.

With nothing that I could find to go on, I started to draw something symmetric.

I'm still looking for suggestions here.

Figuring something like 24" wide, 20" deep on a 2" thick board but only cutting 1" deep, this is what I came up with. Interesting enough, I figure I'll have to carve it and try it out for me to know if it is even close.

Something like this? I have some tractor seat models at hogancnccrafts.com that might help.

Sharkcutup

Here you go just page down for the seats. http://www.designsbyphil.com/3d-file-share.html

Tony

sharkcutup wrote:Something like this?

Tractor Seat Model B.jpg

I have some tractor seat models at hogancnccrafts.com that might help.

Sharkcutup

Yes Sharkcutup. What are the dimensions? How wide, long and deep? The dimensions will really help me.

Thanks.

hogancnccrafts.com, fake site, don't work

Tony

Bill Z take a look here and download the files http://www.designsbyphil.com/3d-file-share.html

Tony

17" x 17" x 2.0"

Sharkcutup

tonydude wrote:Here you go just page down for the seats. http://www.designsbyphil.com/3d-file-share.htmlparis airports transfers

Tony

Thank you very much