Router is not following g-code

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

User avatar
Kayvon
Posts: 552
Joined: Tue Oct 21, 2014 11:46 pm

Re: Router is not following g-code

Post by Kayvon »

Kayvon wrote:Incidentally, when you're choosing the Shark post-processor file, you can choose either mm or inches and it will work fine. It's a common misconception on these forums that the units must match what you used to create the design. Not true at all--the software will convert the units for you, then the CNC machine will interpret those units and turn them into the same length. No matter which you choose, it'll come out correctly.
You can choose the inch one, too. Both will work.

Post Reply