Hi,
I'm new to CNC and deciding on a machine. I looked at quite a few brands and narrowed it down to just a couple, one being NWA. I really like the Shark HD510, but it's a bit more than I want to spend and probably a bit too large for my small shop.
I then decided to step it down a notch and on the NWA site they show the Shark II. Seems to be closer to the size and amount i want to spend. Then i went to the Woodcraft site, they show the Shark HD500, which looks like it"s really the same as the one on the NWA site. Rockler didn't show either one.
So, is the Shark II and HD500 the same machine? Is the HD500 just a smaller HD 510/520? Any benefit buying from one place or another?
Any thoughts are appreciated.
Shark II vs Shark HD500
Moderators: ddw, al wolford, sbk, Bob, Kayvon