Page 1 of 1

HD520 extended bed maintenance

Posted: Fri Jun 18, 2021 4:51 pm
by edwinwhitesel
So I purchased the 6mm grease hun head and attached it to a normal grease gun. the challenge that I have is actually getting any grease to go into the zirk fittings. the 6mm head does not snap over the zirk fitting like a normal automotive grease gun. And even with the z axis carriage all the way down there is no way to align the grease gun directly over the zirk fittings. Seems like a pretty poor design to me. Am I missing something?

Has anyone else had this problem and if so, do they have a solutions?


Help please.....