CNC Shark Forum

I have a Next Wave CNC Shark sd110 and exclusively use Vectric Desktop SW. I use the Touch Screen Pendant (with USB Memory stick) as my controller interface.
When using v10 the code runs instantly when pressing start and the arms are moving instantaneously. The new v11 has a delayed start of ~5-7 seconds before any movement. In searching the G-code, there is no G04 present. What changed between versions/patch?
NOTE: In checking with Vectric website, under post processors, it appears they added a 6-second delay (added as of 6/11/21). Curious as to why!?!

RMC_Florida:

Likely to allow the spindle to come up to speed, in cases where the user purchased the new controller-set spindle speed.

Cheers!

Rando

Here is the reply from nextwave

https://nextwaveautomation.zendesk.com/ ... 3024275085

Tony