pendent not working
Moderators: ddw, al wolford, sbk, Bob, Kayvon
-
- Posts: 1
- Joined: Sun Aug 15, 2021 5:39 pm
pendent not working
The pendent on my Shark HD510 has stopped working. When I jog the Z axis down, the X and Y move. On another note the pendent loses the firmware profile after being turned off. I have a flash drive with the firmware profile on it, that I use during initial startup.
Re: pendent not working
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.