Ordered a HD 500 today

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

Post Reply
cookie58
Posts: 4
Joined: Wed Jul 05, 2023 4:29 pm

Ordered a HD 500 today

Post by cookie58 »

Hey Fellas. I placed my order today for a HD 500. I hope that it doesnt become another fixture in my workshop. I asked earlier if there was a spindle adapter for a Makita router. I really would like to use my router for the expense factor and also, for I like the Makita router. The diameter of the router is 81.52 mm and the clamp that comes with it is 3.5". I can only find 80 mm clamp on line. Can anyone give me any information on this. Thanks, ever so much.

Poptime
Posts: 4
Joined: Thu Nov 24, 2022 12:47 pm

Re: Ordered a HD 500 today

Post by Poptime »

I would contact Nextwave with this. Pretty good at answering and I’m betting they can set you right up.

cookie58
Posts: 4
Joined: Wed Jul 05, 2023 4:29 pm

Re: Ordered a HD 500 today

Post by cookie58 »

I found a piece of aluminum pipe that was the exact diameter (3.5") of the router clamp on ebay and done just a little lathe work on the inside and cut a 1/2 inch slot in it for compression and it works perfectly. It seems that Makita is a odd size that has been forgotten, at least for now. However they say a Makita works well for this application. I am just now getting into the hobby of CNCs and will need help later on. Thanks.

User avatar
Bob
Posts: 1264
Joined: Sun Aug 08, 2010 3:35 pm

Re: Ordered a HD 500 today

Post by Bob »

Nice solution. Thanks for the update.
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)

Post Reply