Page 2 of 2
Re: Router tip does not reach cnc bed or spoil board
Posted: Thu Mar 28, 2024 12:19 pm
by jmarsz
I had unknowingly left tge plastic rings on the router. Which lifted the router out of the holder.
Remove the depth adjustment rings on the router. I didn't know they came off.
Re: Router tip does not reach cnc bed or spoil board
Posted: Thu Mar 28, 2024 12:20 pm
by jmarsz
I actually had more prompt and friendly support from the Facebook group. Some of your replies were not helpful in the least. Your need to look down on new folks doesn't belong here.
Re: Router tip does not reach cnc bed or spoil board
Posted: Sat Mar 30, 2024 12:38 pm
by Bob
jmarsz wrote: ↑Thu Mar 28, 2024 12:19 pm
I had unknowingly left tge plastic rings on the router. Which lifted the router out of the holder.
Remove the depth adjustment rings on the router. I didn't know they came off.
jmarsz,
Thank you for sharing the solution to your problem. I'm sure it will be of help to others.
Bob