Rotational speed

Everything 4th Axis

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Posts: 1
Joined: Fri May 10, 2019 7:24 pm

Re: Rotational speed

Post by Ronski »

I ended up finding an answer on another forum ( ).

Basically you just increase the feed rate by alot, it would be more ideal to only increase the feed rate that is to be converted into the A axis rotational movement, but I cannot seem to find a means to do that within the Vcarve 9.5 software, or the Shark CNC.

Post Reply