Page 1 of 1

Rotational speed

PostPosted: Thu May 23, 2019 12:21 pm
by Ronski
Hello All,

New to the forum so please forgive any newbie transgressions.

I am machining some basic spindles, with stepped shoulders for interlocking into some flat cut parts.
After some teething everything is great with my NWA 4th axis, except it is just so very slow when rotating.

Is there anyway to increase the rotational speed? I cannot seem to find anything in my looking around.

Thanks,
Ryan

Re: Rotational speed

PostPosted: Fri Jun 07, 2019 8:07 am
by Ronski
I ended up finding an answer on another forum ( https://forum.vectric.com/viewtopic.php?f=38&t=23640 ).

Basically you just increase the feed rate by alot, it would be more ideal to only increase the feed rate that is to be converted into the A axis rotational movement, but I cannot seem to find a means to do that within the Vcarve 9.5 software, or the Shark CNC.