first 3D project
Posted: Mon Mar 17, 2014 11:55 am
Here is my first project using Vector Art 3D
Ken
Ken
CNC Shark Forum
The place to talk about, learn about, and even help teach others about the CNC Shark Routing System
https://www.cncsharktalk.com:443/
first 3D project
Page 1 of 1
Re: first 3D project
Posted: Mon Mar 17, 2014 12:08 pm
Ken " ya nailed it" Nice lines,paint looks great.Keep cranking them out. Basecircle
Re: first 3D project
Posted: Mon Mar 17, 2014 12:10 pm
Great work for your first 3D project. Nice crisp lines and love the color.
Tony
Tony
Re: first 3D project
Posted: Thu Mar 20, 2014 5:15 am
Excellent !!!!
Re: first 3D project
Posted: Sat Mar 29, 2014 7:46 am
Did great
Re: first 3D project
Posted: Fri May 02, 2014 8:53 pm
Wow great job, What did you use for paint? Can you tell I'm new at this cnc.. When I do signs just from routing I use sanding sealer before I even sand and paint does not run..
Seabreezr
Seabreezr
Re: first 3D project
Posted: Fri May 02, 2014 9:14 pm
seabreezr
After routing I brushed on a coat of shellac then painted with acrylic craft paint that my wife had, when that dried I used my random orbit sander and sanded off the shellac and that removed all the unwanted paint. I then put on applied two coats of spray lacquer from a rattle can I got from Home Depot. I sanded with 400 grit between coats. It is really very easy to get professional looking results. I suspect you could also use spray shellac and get similar results without the smell associated with lacquer.
Ken
After routing I brushed on a coat of shellac then painted with acrylic craft paint that my wife had, when that dried I used my random orbit sander and sanded off the shellac and that removed all the unwanted paint. I then put on applied two coats of spray lacquer from a rattle can I got from Home Depot. I sanded with 400 grit between coats. It is really very easy to get professional looking results. I suspect you could also use spray shellac and get similar results without the smell associated with lacquer.
Ken