Nut bowl using Fluting tool
Posted: Sun Jan 13, 2019 10:05 pm
Created this as a way to test how to create a bowl with the Fluting tool. I plan to keep working on how to get this accomplished with various shapes and sizes but I think it was a decent start.
I used a log segment from a Locust tree we cut down last year. It was a small 6.6 x 6.5 x 1.75 piece but the bit depth is limited so I don't think I would want to go much deeper. I set the segment area to 5.75" and created 60 segments to ensure I had a significant amount of crossover in the passes. As well, I stepped the bit up to a .5" ball nose on a .5" shaft as I wanted to ensure the stability of the bit. This also provided a slightly larger flat on the bit because of it's manufacturing design. I'm not sure why but my .5" ball nose bits on .25" shafts are more round and have a smaller flat (if any). The whole process took about 40 minutes to run but I think it turned out fair. The cross over lines were pretty easy to eliminate with an 80 grit sponge and then finished with a 180 and 220. It was sealed with a butcher block sealer as I think it will be used as a nut dish.
Steve
I used a log segment from a Locust tree we cut down last year. It was a small 6.6 x 6.5 x 1.75 piece but the bit depth is limited so I don't think I would want to go much deeper. I set the segment area to 5.75" and created 60 segments to ensure I had a significant amount of crossover in the passes. As well, I stepped the bit up to a .5" ball nose on a .5" shaft as I wanted to ensure the stability of the bit. This also provided a slightly larger flat on the bit because of it's manufacturing design. I'm not sure why but my .5" ball nose bits on .25" shafts are more round and have a smaller flat (if any). The whole process took about 40 minutes to run but I think it turned out fair. The cross over lines were pretty easy to eliminate with an 80 grit sponge and then finished with a 180 and 220. It was sealed with a butcher block sealer as I think it will be used as a nut dish.
Steve