Page 1 of 1
Foot stool with ball and claw feet
Posted: Wed Dec 16, 2020 7:04 pm
by BillK
Hi. I’ve been away for a while.
Here’s something I recently completed. A footstool with feet. Actually claws, with talons.
Created the 3D model, then figured how to cut it without a rotary since I don’t have one.
Re: Foot stool with ball and claw feet
Posted: Wed Dec 16, 2020 7:05 pm
by BillK
More pics
Re: Foot stool with ball and claw feet
Posted: Sat Dec 19, 2020 12:07 pm
by mcsteve
Really cool design. Nice work.
Re: Foot stool with ball and claw feet
Posted: Mon Jan 18, 2021 7:57 am
by Darn_Near
Beautiful work!!! I've been thinking of TRYING the same thing and like you I do not have a rotary attachment. I'll just keep winding my butt and scratching my watch until I figure it out. Seeing yours has propelled me into looking at it more serious. Thanks and again BEAUTIFUL JOB....
Re: Foot stool with ball and claw feet
Posted: Mon Jan 18, 2021 10:04 am
by BillK
Darn_Near wrote: ↑Mon Jan 18, 2021 7:57 am
Beautiful work!!! I've been thinking of TRYING the same thing and like you I do not have a rotary attachment. I'll just keep winding my butt and scratching my watch until I figure it out. Seeing yours has propelled me into looking at it more serious. Thanks and again BEAUTIFUL JOB....
Thanks! I wrote this up extensively on the vectric forum, actually in 3 posts. If you look at this post, about 3/4 of the way down you’ll see links to the other 2 posts
https://forum.vectric.com/viewtopic.php?f=29&t=35974
This is done with 4 sided machining, but there is a quirk in the software that you need to work around and I describe it in those posts.
Thanks again.