Aluminum

Browse around for inspiration, or share your work to inspire others!

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
JMOlshefski
Posts: 9
Joined: Tue Jul 01, 2014 4:12 pm

Aluminum

Post by JMOlshefski »

I am cutting a 1/4 deep hole by 2 3/8 in aluminum with 1/4 router bit any recommendations on:

Cutting Parameters:
Feeds and Speeds:
Number of Passes:
Offset verses Raster:
Climb verses Conventional:[/list]

Thanks
Joe

User avatar
Bob
Posts: 1252
Joined: Sun Aug 08, 2010 3:35 pm

Re: Aluminum

Post by Bob »

Joe,
The best advice I can give you is to contact Rando (Do a search). Thom is incredibly experienced with cutting aluminum. Also, if you search this forum, you will find lots of information on this subject.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)

Post Reply