help lost

How-to videos on the CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
tfewox
Posts: 2
Joined: Thu Dec 15, 2016 5:55 pm

help lost

Post by tfewox »

trying to figure out how to set this tool up right new to this need help I put in two pic trying to get the most out of bit using aspire 9.5 thank you
Attachments
Capture tool shot.PNG
Capture tool 2.PNG

mikesolema
Posts: 1
Joined: Wed Oct 27, 2021 8:38 am

Re: help lost

Post by mikesolema »

Thanks for this interesting information!

tonydude
Posts: 1572
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: help lost

Post by tonydude »

tbn.jpg
tfewox,
here is my setup for a 1/8 tapered ball nose, been doing this for 13 yrs

Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.

Post Reply