Page 1 of 1
Control box on hd plus doesn;t pass test
Posted: Sun May 20, 2012 9:07 am
by jimbob45
I have just received my CNC Shark pro plus HD and it will not pass the first power up. The manual states that the blue light should come on and stay on. I get a steady red and the amber and blue lights flash on and off. It is the weekend so I can't contact Next Wave for help. Has anyone experienced this problem??
Re: Control box on hd plus doesn;t pass test
Posted: Sun May 20, 2012 10:28 am
by jeb2cav
Good morning - I'd continue with setup and just see if it 'works'. There may have been a minor change in how the LEDs function, or a goof in the manual. Certainly after you power up and connect to the computer, the lighting should appear as described.
Re: Control box on hd plus doesn;t pass test
Posted: Mon May 21, 2012 12:03 pm
by jimbob45
Thanks for the info Joe. It now passes the tests.
Re: Control box on hd plus doesn;t pass test
Posted: Mon May 21, 2012 1:03 pm
by shicks1015
I had the same problem when I set mine up few weeks back. The blue light never came on but it runs fine. I posted this in an earlier thread if you want to search back.
Shawn