pinout for LED?

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
CharliesWoodStuff
Posts: 24
Joined: Sun Nov 04, 2018 11:57 am
Location: Maysville, WV

pinout for LED?

Post by CharliesWoodStuff »

Is there a pinout on the controller or the spindle controller that I can tap to install a small LED strip?

User avatar
Kayvon
Posts: 552
Joined: Tue Oct 21, 2014 11:46 pm

Re: pinout for LED?

Post by Kayvon »

If you open the controller box, the power supply should have its outputs labeled. You'll want to be careful not to overload the power supply, so ensure your LED strip isn't too long.

CharliesWoodStuff
Posts: 24
Joined: Sun Nov 04, 2018 11:57 am
Location: Maysville, WV

Re: pinout for LED?

Post by CharliesWoodStuff »

Thank you for the answers!

Post Reply