Connectors on axis cables

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
relayerbob
Posts: 2
Joined: Wed Jan 23, 2019 6:57 pm

Connectors on axis cables

Post by relayerbob »

Heelo! In addition to the DB9 connector at the end of each axis cable there is another small silver connector. What is that used for? Is it a limit switch?

OCEdesigns
Posts: 105
Joined: Fri Jan 11, 2019 8:26 am

Re: Connectors on axis cables

Post by OCEdesigns »

It's just a ground cable. The sharks do not have limit switches. I wish they did!!
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 10.5
Maker of many chips

relayerbob
Posts: 2
Joined: Wed Jan 23, 2019 6:57 pm

Re: Connectors on axis cables

Post by relayerbob »

OK, thannks!

Post Reply