Installing 220v 3rd party spindle

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: sbk, al wolford

Installing 220v 3rd party spindle

Postby Dljones10 » Fri Nov 29, 2019 9:21 pm

Just bought the Shark HD5. Was wondering if anyone installed a spindle bought off amazon particularly the 220v, 2.2kw, 80mm water cooled spindle? If so is it any harder to install than the one sold by NW? From what I have read the only difference is that NW's VFD comes pre-programmed and you would get NW's support on it. NW makes the 80mm bracket which I ordered.
The link to the spindle that I am talking about.
https://www.amazon.com/Spindle-Kits%EF% ... NrPXRydWU=

Thanks
Dljones10
 
Posts: 1
Joined: Tue Nov 26, 2019 12:16 pm

Re: Installing 220v 3rd party spindle

Postby Junior » Sat Nov 30, 2019 1:28 am

These are the settings I needed for mine, left all others alone. Only diff is I have a 220 1.5kw

If it won't take the settings you have the lock on PD000=0 you will have a (1 ) for this parameter, it needs to be 0

Here are all the correct settings for your Drive

Huanyang Mactec54
PD000 = 0 for Parameter unlock. For Parameter Lock use (1)
PD001 = 0 (1 For Remote Control)
PD002 = 1 (1 For Internal Pot Control)
PD003 = 400
PD004 = 400
PD005 = 400
PD007 = 20
PD008 = 220
PD011 = 120 (Minimum Setting 120)
PD009 = 15
PD010 = 8
PD013 = 08 is for Factory reset, Only use this to set VFD to Factory Default
Settings
PD014 Accel=12 ( Adjust to suit)
PD015 Deccl=12 (Adjust to suit) ( PD15 is ignored IF PD26=1 Then the Spindle will
Coast to a Stop)
PD141 = 220 ( Motor Rated Voltage )
PD142 = 7 ( Motor Max Amps) (Set for your motor Amp Rating 2.2Kw Spindle 9 amp Max)
(Set for your motor Amp Rating 1.5Kw Spindle 7 amp Max)
PD143 = 2 ( Motor Number of Poles)
PD144 = 3000 (Max Motor RPM) =3,000= (24,000)

PD70 = 1 ( This may need to be set to 1 if Control Voltage is 0-5v )

PD72 = 400

PD73 = 120 ( 100 Minimum Setting )
Junior
 
Posts: 13
Joined: Sun Jun 17, 2012 9:48 pm


Return to Setting up the Shark

Who is online

Users browsing this forum: No registered users and 1 guest