Motor control not turning on my router

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Creekwood
Posts: 9
Joined: Wed Aug 26, 2020 9:59 pm

Motor control not turning on my router

Post by Creekwood »

I have the HD-4 (brand new) had a (Carvewright for years) with V-Carve and Bosch Router.
First project from the Randy Johnson CNC Essentials came out great! The second project (which I spiced up the same) but now the router would not turn on???? So I just plug the it in directly and got it done. But bet I did something wrong? I opened the processor box didn't see a fuse.

User avatar
Bob
Posts: 1252
Joined: Sun Aug 08, 2010 3:35 pm

Re: Motor control not turning on my router

Post by Bob »

CW,
The fastest way I have found to answer a question like this is to send an email directly to Next Wave: support@nextwavecnc.com
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)

Creekwood
Posts: 9
Joined: Wed Aug 26, 2020 9:59 pm

Re: Motor control not turning on my router

Post by Creekwood »

Thanks Bob I will, I know it is something I am doing :shock:

Post Reply