Question about Shark SD110

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Kfosh
Posts: 8
Joined: Wed Sep 08, 2021 9:24 pm

Re: Question about Shark SD110

Post by Kfosh »

Had that problem with touch plate I got to make sure little magnet is clean ant. On a flat on nut by bit and turn plate to where plug in is towards top so plate will set flat

Max
Posts: 6
Joined: Mon Jan 31, 2022 10:26 pm
Location: California

Re: Question about Shark SD110

Post by Max »

Hey SD110er"s, I also realized that you don't get the full 2"x18" bed on the SD110. There isn't quite enough working room once you set it up. What got me was the word "Work Tabel". I figured that was the area you have to work with. But when I really looked at it, I came up with a safe work area of about 12"x12". Did anyone else get that? I realized it when I was designing a spoiler board. My grids can only be 1" square on a 12x12 grid to be evenly spaced. You can't get the grids on a 12"x18" bed because the router doesn't go back the whole 18". Disappointed about that. But I'll have to figure something. :o
Max :D

Post Reply