Page 2 of 2
Re: Question about Shark SD110
Posted: Wed Sep 08, 2021 10:14 pm
by Kfosh
Had that problem with touch plate I got to make sure little magnet is clean ant. On a flat on nut by bit and turn plate to where plug in is towards top so plate will set flat
Re: Question about Shark SD110
Posted: Wed Feb 02, 2022 8:24 pm
by Max
Hey SD110er"s, I also realized that you don't get the full 2"x18" bed on the SD110. There isn't quite enough working room once you set it up. What got me was the word "Work Tabel". I figured that was the area you have to work with. But when I really looked at it, I came up with a safe work area of about 12"x12". Did anyone else get that? I realized it when I was designing a spoiler board. My grids can only be 1" square on a 12x12 grid to be evenly spaced. You can't get the grids on a 12"x18" bed because the router doesn't go back the whole 18". Disappointed about that. But I'll have to figure something.
