just got a demo hd5 from rockler, where i work.
i but the material thickness at .75, and tell the cut to be .78 and it only cuts to .40!
the z axis and bit can reach the alum. bed to i know i have the travel. i have my cut material that is to be cut on a .75 waste board.
z is zeroed on my cut piece. i am using the correct processor because everything else is coming out correct except the depth of cut
what can i do to fix it?
hd5 cutting only half the depth
Moderators: al wolford, sbk, Bob, Kayvon
Re: hd5 cutting only half the depth
I would be real curious to look at the crv file. It's easier to check your settings this way.
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)