I need help

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
odinswoodshop
Posts: 1
Joined: Mon May 31, 2021 4:05 pm

I need help

Post by odinswoodshop »

Hello all. Brand new here as I just purchased my very first cnc. It is a very old shark "pictures below". And I need some help with a few setup things. As I said this model I believe is kinda old, I unfortunately cannot find a model number or serial number anywhere. Also I do not know what kind of software I should look at. I had to order a serial to usb cable just to connect a computer. Any help would be greatly appreciated.

Thank you
Erik
Attachments
20210531_154638.jpg
20210531_165157.jpg
20210531_165226.jpg

tonydude
Posts: 1581
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: I need help

Post by tonydude »

Send email to support@nextwavecnc.com for control panel 2.1 to run your machine. Also you can call 419-318-4822 9AM-5PM EST Mon-Fri.

https://www.nextwavecnc.com/support

https://www.nextwavecnc.com/frequentlyaskedquestions

Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.

Post Reply