Removing my 4th Axis Pendant settings

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Posts: 1
Joined: Sat Jun 05, 2021 12:28 pm

Removing my 4th Axis Pendant settings

Post by akrumsee »

So I installed the mini 4th axis on my HD5 several months ago. I had to make two changes in settings on the Pendant under Apps/4th Axis:

1) Change 3D Mode to 0
2) Change 4th Axis to "2 - Lathe Type A"

My question... What should these be set back to now that I've removed the 4th Axis?


Post Reply