Pausing cut

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
W2csa
Posts: 4
Joined: Sun Nov 26, 2023 5:45 pm

Pausing cut

Post by W2csa »

Hi all. I have purchased a Next Wave Shark HD510 with a 2HP water cooled spindle.
If I push the pause button, during a carve on the pendant, the CNC stops but the water pump continues to run.
If I want to pause overnight, say for a very long carve, will the water pump running be a issue?
Can I unplug the pump and replug the next morning?
Thanks for reading.

Post Reply