Controller not following G Code?

Discussion specifically about the Shark's bigger brother, the CNC Shark Pro

Moderators: sbk, al wolford

Re: Controller not following G Code?

Postby rungemach » Thu Feb 16, 2012 11:49 am

Hello Rich

the cost of my x axis bearing conversion was about 170.00 for the bearings and rods, about 40.00 for aluminum plate , and 20.00 or so for hardware.
Plastics like hdpe might work for the z axis parts, but I did them in aluminum for strength, and I wanted to save my original plastic parts.
This change helped the z axis quite a bit and did improve the z as well.

I have the Autocad and Vectric files for both an aluminum version and for a plastic version.
Just PM me if you want them, I will be happy to try and help if I can.

Posts: 457
Joined: Mon Aug 02, 2010 8:24 am
Location: Sarasota, Florida

Re: Controller not following G Code?

Postby kevinp » Tue Jan 08, 2019 2:48 pm

Realize this is a VERY old thread, but BOB, do you still have the DXF files for the aluminum z skeleton for the Shark Pro (offered up in your post a couple above this one). I've tried PM'ing you, but PM'ing appears to be disabled for new users.
Posts: 5
Joined: Tue May 26, 2015 3:21 pm


Return to Shark Pro

Who is online

Users browsing this forum: No registered users and 1 guest