Page 1 of 1
not turning on?!
Posted: Wed Apr 10, 2013 11:06 am
by usd294
the cnc machine is not turning on, is this a common issue, or did our not usiung a surge protector bite us in the butt?
Re: not turning on?!
Posted: Wed Apr 10, 2013 12:28 pm
by basecircle
Open the controller box.There should be a fuse,If it is blown replace it.There are a few posts on this.radio shack has the fuse.Also check that your e stop is not pushed in.Iam sure others will chime in on this.Basecircle
Re: not turning on?!
Posted: Thu Apr 11, 2013 8:08 am
by jeb2cav
If you look in the Shark Owner's Manual - available from the NWA Downloads page - you'll find details on the Shark Control Box fuses.
Re: not turning on?!
Posted: Tue Jul 30, 2013 2:46 pm
by usd294
forgot to reply, the power cord was shot, replaced power cord and ta-da