Copper
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 5
- Joined: Mon Jul 09, 2012 11:15 am
Copper
Hi trying a first attempt at engraveing copper sheet with my shark pro hd, any suggestions. As far as speed and what type of bit? Thanks
Re: Copper
I have engraved brass plaques and used the v carve bits. I used the speeds and feeds that were set up in the tool library and they seem to work fine. I always slow the feed rate down and gradually increase it as needed. You may have to trial and error the depth of cut to suit.