My cnc stop in middle of machining or got an offset in Y
Posted: Mon Jul 10, 2017 7:44 am
Hello,
Yesterday, I machined a large laminated panel in tiling mode, length of this one of 2400 mm.
Usually, I have never used this kind of machining.
I had 3 problems during this day, my cnc was stopped during machining, (2 hours later) in the middle of the machining, the cnc shifted 70cm in Y from the origine .
One hour later, the same but just 3 cm in X and 2 hours after 2 cm in X.
My computer is a small netbook Asus 1215N with Atom processor (1,8 G), let me know if for Control Panel 2.1 that's enough.
I haven't got an antivirus or other softwares installed in the computer ,I never use internet with it.
Have you already got troubles like these with tiling mode?
Thanks to let me know if you 've got solution of my problemes.
Jean-Luc
Yesterday, I machined a large laminated panel in tiling mode, length of this one of 2400 mm.
Usually, I have never used this kind of machining.
I had 3 problems during this day, my cnc was stopped during machining, (2 hours later) in the middle of the machining, the cnc shifted 70cm in Y from the origine .
One hour later, the same but just 3 cm in X and 2 hours after 2 cm in X.
My computer is a small netbook Asus 1215N with Atom processor (1,8 G), let me know if for Control Panel 2.1 that's enough.
I haven't got an antivirus or other softwares installed in the computer ,I never use internet with it.
Have you already got troubles like these with tiling mode?
Thanks to let me know if you 've got solution of my problemes.
Jean-Luc