Fusion 360, its CAM post processing and personal experience
Moderators: ddw, al wolford, sbk, Bob, Kayvon
-
- Posts: 227
- Joined: Mon Aug 13, 2012 7:16 pm
Fusion 360, its CAM post processing and personal experience
Just diving into fusion 360 due to the advantages it offers over most design programs and wondering if anyone would care to share thier experiences using it with a shark. Anyone?
"I'm not smart, I just remain on problems longer"
Albert Einstein
Making many BTU by experimentation. ...some days it gets too warm
Albert Einstein
Making many BTU by experimentation. ...some days it gets too warm
Re: Fusion 360, its CAM post processing and personal experie
I don't have any personal experience with it, but here's a thread about it:
http://www.cncsharktalk.com/viewtopic.p ... 47&start=0
And another about a post processor for it:
http://www.cncsharktalk.com/viewtopic.php?f=10&t=5196
http://www.cncsharktalk.com/viewtopic.p ... 47&start=0
And another about a post processor for it:
http://www.cncsharktalk.com/viewtopic.php?f=10&t=5196