I have just set up my machine, loaded everything in, went to load g-code for trial piece - Bulls_Head - loaded, but got an error
---- " load error : ERROR line 1 bad character used ".
Can anyone help before I call support ???
Thanks - John
New pro-plus with error
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: New pro-plus with error
Hi - give this post a look and see if it helps - http://www.cncsharktalk.com/viewtopic.php?f=9&t=845
For a more detailed post on post processors - and it sounds like this is your issue - try http://www.cncsharktalk.com/viewtopic.php?f=10&t=109
Please let us know if this solved this problem, or if you still need some ideas. Good luck!
For a more detailed post on post processors - and it sounds like this is your issue - try http://www.cncsharktalk.com/viewtopic.php?f=10&t=109
Please let us know if this solved this problem, or if you still need some ideas. Good luck!
Re: New pro-plus with error
Almost ever time I have seen this error someone it trying to load the crv file rather then the tap file.
People make this mistake when they name the vcarve crv file the same name as the tap file they are going to use.
Tim
People make this mistake when they name the vcarve crv file the same name as the tap file they are going to use.
Tim
Re: New pro-plus with error
Thanks for the help. It was just file mis-management. Everything is rolling along fairly smoothly now. I'm back to the learning curve,
and I am making productive sawdust.
John
and I am making productive sawdust.
John