is this machine adequate for guitar building?
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 2
- Joined: Sat Jan 08, 2011 11:18 pm
is this machine adequate for guitar building?
I am considering buying one of these machines for electric guitar building. Does this machine have adequate power for doing this or is this basically a sign making machine?
Re: is this machine adequate for guitar building?
Hi Justin,
It seems like there are some folks using the Shark to do that. It may require upgrading the VCarve Pro software to Aspire after purchase.
http://www.cncsharktalk.com/viewtopic.p ... itar#p1833
http://www.cncsharktalk.com/viewtopic.p ... itar#p1726
It seems like there are some folks using the Shark to do that. It may require upgrading the VCarve Pro software to Aspire after purchase.
http://www.cncsharktalk.com/viewtopic.p ... itar#p1833
http://www.cncsharktalk.com/viewtopic.p ... itar#p1726
-
- Posts: 2
- Joined: Sat Jan 08, 2011 11:18 pm
Re: is this machine adequate for guitar building?
That is not a problem I have access to mastercam