bowl cutters
Moderators: al wolford, sbk, Bob, Kayvon
bowl cutters
does anybody use bowl cutters on their shark i have a 3/4 and 1 1/4 i would like to use was woundering about speeds, feed rate and cut depth
-
- Posts: 227
- Joined: Mon Aug 13, 2012 7:16 pm
Re: bowl cutters
I personally have never attempted to use or own them, but my experience with the shark lead me to believe it's possible. As always it's the speeds and feeds that make all the difference.
"I'm not smart, I just remain on problems longer"
Albert Einstein
Making many BTU by experimentation. ...some days it gets too warm
Albert Einstein
Making many BTU by experimentation. ...some days it gets too warm
Re: bowl cutters
I have made a couple candy dishes and I use a 1-1/4' bowl cutter with no problem.
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 12.010, photo vcarve, cut3D.cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 12.010, photo vcarve, cut3D.cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
-
- Posts: 33
- Joined: Thu Sep 23, 2010 7:52 am
Re: bowl cutters
Tony, do you just set the bowl cutter up as an endmill.
Gerald
Gerald