Has anyone a good file for making a vacuum boot for a shark 4 HD?
Or did it exist somewhere?
Thanks
Shark 4 vacuum boot template
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Re: Shark 4 vacuum boot template
I would give you mine but it is designed to fit my router and a 4 inch vacuum hose.
V-Carve can do it in a blink. Probably take less time to do it on V-Carve than wait for a posting.
It is just 2 circles where one is the size of your router base, the other is the size of your vacuum hose connector. Most include a way to tighten the boot to your router base and that is creative sometimes.
It doesn’t have to be two pieces but does help.
Here are some Youtubes you can check out. I like the first one best., it is simple and cheap (just my opinion).
https://www.youtube.com/watch?v=bu3PzlW1XxI
https://www.youtube.com/watch?v=jqDR3b1lLxg
https://www.youtube.com/watch?v=jDpyQdaGBgE
https://www.youtube.com/watch?v=WoAX7dCk3Ro
Hope this helps.
V-Carve can do it in a blink. Probably take less time to do it on V-Carve than wait for a posting.
It is just 2 circles where one is the size of your router base, the other is the size of your vacuum hose connector. Most include a way to tighten the boot to your router base and that is creative sometimes.
It doesn’t have to be two pieces but does help.
Here are some Youtubes you can check out. I like the first one best., it is simple and cheap (just my opinion).
https://www.youtube.com/watch?v=bu3PzlW1XxI
https://www.youtube.com/watch?v=jqDR3b1lLxg
https://www.youtube.com/watch?v=jDpyQdaGBgE
https://www.youtube.com/watch?v=WoAX7dCk3Ro
Hope this helps.
-
Fetustician
- Posts: 2
- Joined: Sun Dec 25, 2016 7:13 pm
Re: Shark 4 vacuum boot template
Thanks Bill
This is most helpful indeed! I was trying to attach on the router and that router support and having trouble making pockets for all these screws. Also interesting to see the difference between the router, that I have, and the spindles. The router blows a ton of air on the piece, so the dust doesn't accumulate on the piece but it's blown everywhere. I also like the plastic so you can still see through.
Thanks so much!
This is most helpful indeed! I was trying to attach on the router and that router support and having trouble making pockets for all these screws. Also interesting to see the difference between the router, that I have, and the spindles. The router blows a ton of air on the piece, so the dust doesn't accumulate on the piece but it's blown everywhere. I also like the plastic so you can still see through.
Thanks so much!