it ran 1/2 inch on all 3Buc wrote:Here is a test .tap file. It is located in your documents folder, CNC shark. X, Y, and Z axis' will move 1" and return to 0,0,0. Run this without a router bit in collet and see if it moves one 1" on all three axis'.
Your .TAP file ran OK on my machine.
Buc
signs
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: signs
Re: signs
what does this meanbaby15 wrote:it ran 1/2 inch on all 3Buc wrote:Here is a test .tap file. It is located in your documents folder, CNC shark. X, Y, and Z axis' will move 1" and return to 0,0,0. Run this without a router bit in collet and see if it moves one 1" on all three axis'.
Your .TAP file ran OK on my machine.
Buc
Re: signs
On the shark control panel itself you do have inches selected right?
If that's not it then you need to get a hold of Al Wolford or Tim Owens about a control box.
I don't think there are jumpers in the newer controllers.
If that's not it then you need to get a hold of Al Wolford or Tim Owens about a control box.
I don't think there are jumpers in the newer controllers.
Re: signs
yes have inches selectedSPH01 wrote:On the shark control panel itself you do have inches selected right?
If that's not it then you need to get a hold of Al Wolford or Tim Owens about a control box.
I don't think there are jumpers in the newer controllers.
Re: signs
What's the name on the post processor you downloaded.
Right one http://www.nextwaveautomation.com/Downl ... cs_inch.pp
wrong one http://www.nextwaveautomation.com/Downl ... SB_inch.pp
Right one http://www.nextwaveautomation.com/Downl ... cs_inch.pp
wrong one http://www.nextwaveautomation.com/Downl ... SB_inch.pp
Re: signs
what do i do with these they are just infoSPH01 wrote:What's the name on the post processor you downloaded.
Right one http://www.nextwaveautomation.com/Downl ... cs_inch.pp
wrong one http://www.nextwaveautomation.com/Downl ... SB_inch.pp
Re: signs
by the way where did you buy the dust collector attached to the machinebaby15 wrote:i lived for years in valley center ca outside of escondido ca. now live by buffalo nySPH01 wrote:Yes it was. The two files in the ZIP is what I ran.
Steve
Re: signs
Try to email Support@nextwaveautomation.com
They will be able to get your problem solved and machining carves to size.
Buc
They will be able to get your problem solved and machining carves to size.
Buc
I have not failed. I've just found 10,000 ways that won't work.
Thomas A. Edison
The Only Easy Day Was Yesterday
Thomas A. Edison
The Only Easy Day Was Yesterday