Some recent projects
Moderators: al wolford, sbk, Bob, Kayvon
Some recent projects
I figure I should share some of the projects I've done recently.
- Attachments
CNC Shark Pro Plus - 12/2014
VCarve Pro, PhotoVCarve, Cut3D
ViaCAD 3D, AutoCAD, Sketchup
BobCAD V28
VCarve Pro, PhotoVCarve, Cut3D
ViaCAD 3D, AutoCAD, Sketchup
BobCAD V28
Re: Some recent projects
Absolutely beautiful work!
How did you secure the candy bowl while you routed it?
How did you secure the candy bowl while you routed it?
Re: Some recent projects
Rough cut to the desired finish dimension then cut the piece in half on the band saw. While I was there I cut a step in both ends to allow for 2 clamps on each end. With a semi flat surface I used my surfacing bit (1") and leveled what would be the bottom by using the jog function in control panel. Now that I had a flat bottom surface, I flipped it over, clamped on each end and then squared the piece onto the table.
To carve out the dish I used several pocket paths set to various depths (found this was the quickest way to get rid of material) using 0.50 and .25 spiral bits. To finish the inside I used a couple of Fluting tool paths so I wouldn't need to spend so much time sanding.
To carve out the dish I used several pocket paths set to various depths (found this was the quickest way to get rid of material) using 0.50 and .25 spiral bits. To finish the inside I used a couple of Fluting tool paths so I wouldn't need to spend so much time sanding.
CNC Shark Pro Plus - 12/2014
VCarve Pro, PhotoVCarve, Cut3D
ViaCAD 3D, AutoCAD, Sketchup
BobCAD V28
VCarve Pro, PhotoVCarve, Cut3D
ViaCAD 3D, AutoCAD, Sketchup
BobCAD V28
Re: Some recent projects
Great design would be a good idea if it was mass produced.