Hey folks,
I am working with Woodworker's Journal on a series of projects for the CNC Shark that they are using in their "Ezine".
The first is for a Butler's Tray and uses the Shark to mill the (fairly complicated) hinge mortises and then cut out the parts.
The email includes a link to download .dxf, VCarve Pro and .tap files for the project. I've already produced another project and am working on a third.
http://www.woodworkersjournal.com/resou ... index.html
Ralph
Woodworker's Journal CNC Shark Files
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
- Consultingwoodworker
- Posts: 333
- Joined: Fri Jul 02, 2010 7:37 am
- Location: Nashville area
- Contact:
Re: Woodworker's Journal CNC Shark Files
thanks again
Re: Woodworker's Journal CNC Shark Files
Thank you for posting
Just what I have been wishing for.
Cheers
Wolffie
Just what I have been wishing for.
Cheers
Wolffie
- Consultingwoodworker
- Posts: 333
- Joined: Fri Jul 02, 2010 7:37 am
- Location: Nashville area
- Contact:
Re: Woodworker's Journal CNC Shark Files
Wolffie,
Be sure to post pics in the show off forum above when you get done!
Ralph
Be sure to post pics in the show off forum above when you get done!
Ralph